The BiSSTRO BiSS interface from PassWorlk YK can access a single BiSS Point-to-Point device and also a chain of BiSS devices.
BiSSTRO is completely transparent and allows to access all signals with an oscilloscope or logic analyzer.
All input pins can be remapped to any output pin using an output remap matrix, allowing to comply with different DB9 pinouts.
Three Resistive loads can be enabled for each of the MA, SLO, SLI pairs.
The solder based jumpers can also be used to map the iC-Haus BiSS adapters SUB-D9 pinning to the Renishaw Resolute SUB-D9 pinning.
BiSSTRO can also be configured to RS232 with a single jumper In case of RS232, the remap matrix can be used to connect RX and TX together for loopback Except the BiSS / RS232 configuration, all other jumpers are solder based.
PassWorld is a development services provider. These developments include all the phases from design to prototype manufacturing.
Specialized support for iC-Haus devices and the BiSS Open Source protocol.